IBM S85 pSeries 680 Service Manual page 189

Table 5. Firmware Error Codes. (continued)
Error Code Description
25A80998 NVRAMRC script evaluation error -
command line execution error
25A80999 NVRAMRC script evaluation error -
stack unbalanced on completion
25B00001 Memory card error
25B00002 Memory card mismatch. One memory
card in a quad does not match the other
three memory cards in the quad.
Action/ Possible Failing FRU
Execution of a command line within the
nvram configuration variable "nvramrc"
(script) resulted in a "throw" being
executed. This script can be modified by
the system firmware SMS utilities, the
operating system, PCI adapter rom
code or utility, or an operator (via the
open firmware script-editing command
nvedit). It may not be possible to
resolve the problem without a detailed
analysis of the nvram script, the current
system configuration, and device tree
contents.
1. The problem can be caused by a
SCSI adapter, whose SCSI bus ID
has been changed from the default
setting, no longer appearing in the
system. This can be caused either
by removing a SCSI adapter, or a
problem with a SCSI adapter.
a. Select the SCSI ID utility from
the SMS menu(s).
1) Verify the list of SCSI
controllers/adapters. If the
list is not correct, suspect a
problem with the adapter(s)
installed but not listed.
2) Select the option to save the
configuration information.
3) Restart the system.
b. If the problem persists, boot the
operating system and verify the
SCSI bus IDs of any
installed/available SCSI
controllers (change as
necessary), and restart the
system.
2. Contact your support representative
for further assistance.
This is a firmware debug environment
error. There is no user action or FRU
replacement for this error.
Replace memory card. See note 5 on
page 157 for memory card location code
information.
Replace the mismatched memory card.
The mismatched memory card is
identified by its location code. See note
5 on page 157 for memory card location
code information.
Chapter 5. Error Code to FRU Index
167