IBM S85 pSeries 680 Service Manual page 172

Table 3. Firmware Checkpoints (continued)
Checkpoint
E1BA
E1BB
E1BC
E1BD
E1BE
E1BF
E1C0
E1C4
E1C5
E1C6
E1D0
E1D3
E1D4
E1DB
150
Service Guide
Description
Enable L2 cache
Set cache parms for burst
Set cache parms for 512KB
Probe for (ISA) mouse
Create op panel node
Create pwr mgmt node
Create ISA ethernet node
Build ISA timer chip node
Create ISA interrupt controller (pic)
node
Create DMA node
Create PCI SCSI node
Create (* wildcard *) SCSI block
device node (SD)
Create (* wildcard *) SCSI byte
device node (ST)
Create floppy controller (FDC) node
Action/ Possible Failing FRU
See the note on page136. When
performing MAP 1540, follow the
MAP steps to perform the system
rack minimum configuration.
See the note on page136. When
performing MAP 1540, follow the
MAP steps to perform the system
rack minimum configuration.
See the note on page136. When
performing MAP 1540, follow the
MAP steps to perform the system
rack minimum configuration.
1. Replace mouse
2. Replace the service processor
card.
Location: U0.1-P1-X1
AIX Location Code: 10-70 or
10-70 to 10-77 1E-xx
3. Replace the I/O planar.
Location: U0.1-P1
4. Go to "MAP 1540: Minimum
Configuration" on page 117.
See the note on page136.
See the note on page136.
See the note on page136.
See the note on page136.
See the note on page136.
See the note on page136.
See the note on page136.
See the note on page136.
See the note on page136.
See the note on page136.