Download  Print this page

Operation Panel Parameter; Prohibition Of Key Operations And Parameter Settings - Toshiba Tosvert VF-AS1 Instruction Manual

The new high-performance inverter.
Hide thumbs

Advertisement

6.36

Operation panel parameter

6.36.1 Prohibition of key operations and parameter settings

 : Parameter write protect selection
 : Operation panel frequency setting prohibition selection
 : Operation panel emergency stop operation prohibition selection
 : Operation panel reset operation prohibition selection
 : Prohibition of change of / during operation
 : All key operation prohibition
 Function
These parameters allow you to prohibit the operation of the RUN and STOP keys on the operation panel
and the change of parameters. Using these parameters, you can also prohibit various key operations.
[Parameter setting]
Title

Parameter write protect selection

Operation panel frequency setting prohibition selection
Operation panel emergency stop operation prohibition

selection

Operation panel reset operation prohibition selection

Prohibition of change of / during operation

All key operation prohibition
Note: For the setting of  to take effect, the inverter needs to be turned off and turned back on after the
setting.
 Resetting method
1) Canceling the  prohibition setting
The setting of only parameter  can be changed at any time, even if it is set to .
2) Canceling the  prohibition setting
When this parameter is set to 1 (key operation prohibited), press and hold down the
more. The message  appears and this setting is canceled temporarily to enable key operation.
To cancel this setting permanently, change the setting of  directly.
Function
F-73
E6581442
Adjustment range
Default setting
:Permit,:Prohibit
:Permit,:Prohibit
:Permit,:Prohibit
:Permit,:Prohibit
:Permit,:Prohibit
:Permit,:Prohibit
key for 5 seconds or
ENT
6

Advertisement

Table of Contents

   Related Manuals for Toshiba Tosvert VF-AS1

Comments to this Manuals

Symbols: 0
Latest comments: