Toshiba Tosvert VF-AS1 Instruction Manual page 16

 Operation panel
RUN lamp
Lights when an ON
Press this key to control
command is issued but no
the function assigned
frequency signal is sent
with a parameter.
out. It blinks when
operation is started.
PRG lamp
Lights when the
inverter is in parameter
setting mode.
MON lamp
Lights when the
inverter is in monitor
mode. Blinks when the
inverter is placed in trip
record display mode.
RUN key lamp
Lights when the RUN
key is enabled.
RUN key
Pressing this key
while the RUN key
lamp is lit starts the
operation.
Note 1:  For details EASY Key functions, refer to Section 5.22.
Note 2: When parameter  is set to , the operation frequency cannot be set even if this lamp is lit.
［Panel indication］
LED display is using the following signs to indicate the operation parameter and so on.
LED indication (number)
０ １ ２ ３ ４ ５
     
LED indication (alphabet)
Ａａ Ｂｂ Ｃｃ Ｄｄ
  
Ｎｎ Ｏｏ Ｐｐ Ｑｑ
  
EASY key [Note 1]
EASY key lamp
Lights when the EASY
key is enabled.
STOP key
Pressing this key while
the RUN key lamp is lit
causes the motor to make
a deceleration stop. Press
the key twice to reset the
inverter after a trip.
６ ７ ８ ９ －
    
Ｅｅ Ｆｆ Ｇｇ
   
Ｒｒ Ｓｓ Ｔｔ
  
Up key
RS485 connector/cover
2-wire RS485 connector. This
connector is used to connect an
optional device, such as an
extended control panel.
Ｈｈ Ｉｉ Ｊｊ Ｋｋ
 
Ｕｕ Ｖｖ Ｗｗ Ｘｘ
 
A-3
E6581442
% lamp
Lights when the unit
is %.
Hz lamp
Lights when the unit is
Hz.
MODE key
Displays the operation
frequency, a
parameter, the cause
of a failure, and so on.
ENTER key
Up/Down key lamp
With these keys, you
can set the operation
frequency while the
Up/Down key lamp is
lit. [Note 2]
Down key
Ｌｌ Ｍｍ
 
Ｙｙ Ｚｚ

1