For 200V/0.4kW to 200V/15kW models and 400V/0.75kW to 400V/18.5kW models, cut off the tabs (part A in the
figure below) on the main circuit terminal cover if necessary for connecting the cables from the power supply.
To wire the main circuit terminal for 200V-18.5kW and above models and 400V-22kW and above models, remove
the front cover.
Remove the screw
Control circuit terminal cover
To wire the control circuit terminal, open the control circuit terminal cover in line with the steps given below.
Control circuit terminal
Open the control circuit terminal cover.
* To open the cover, lift it with your finger
placed at the
part on the right side of
Main circuit terminal
Remove the terminal, if necessary.
* To do so, open the main circuit terminal
cover, loosen the screws that fix the
terminal, using a (-) screwdriver or torx
(T20H) screwdriver, placed your finger on
and pull out the terminal.