Checking The Front Brake Discs; Installing The Front Wheel (Front Brake Discs) - Yamaha MT-01 Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk
b. Turn the front wheel 90° so that the heavy
spot is positioned as shown.
c. If the heavy spot does not stay in that posi-
tion, install a heavier weight.
d. Repeat steps (b) and (c) until the front wheel
is balanced.
L LLL L LLL L L LLL L L LLL
4. Check:
• Front wheel static balance
M MMM M MMM M M MMM M M MMM
a. Turn the front wheel and make sure it stays at
each position shown.
b. If the front wheel does not remain stationary
at all of the positions, rebalance it.
L LLL L LLL L L LLL L L LLL
ET5YU1001

CHECKING THE FRONT BRAKE DISCS

Refer to "CHECKING THE FRONT BRAKE
DISCS" on page 4-24.
Email: info@motomatrix.co.uk
L L LLL L L LLL L LLL
M M MMM M M MMM M MMM
L L LLL L L LLL L LLL
EAS22000
INSTALLING THE FRONT WHEEL (FRONT
BRAKE DISCS)
The following procedure applies to both of the
front brake discs.
1. Install:
• Front brake disc
Front brake disc bolt
18 Nm (1.8 m·kg, 13 ft·lb)
LOCTITE
NOTE:
Tighten the brake disc bolts in stages and in a
crisscross pattern.
2. Check:
• Front brake discs
Refer to "CHECKING THE FRONT BRAKE
DISCS" on page 4-24.
3. Lubricate:
• Oil seal lips
• Collars
Recommended lubricant
Lithium-soap-based grease
4. Install:
• Front wheel
NOTE:
Install the tire and wheel with the mark "1" point-
ing in the direction of wheel rotation.
5. Tighten:
• Front wheel axle
4-10
FRONT WHEEL
®