Installing Or Replacing The Hot-Swap Backplane - Gateway 9315 User Manual

Installing or replacing the hot-swap
backplane
Your server may not have a hot-swap backplane. If your server was ordered with fixed
drives, it will not have a hot-swap backplane.
To install or replace the hot-swap backplane:
1
Follow the instructions in
sure that you turn off the server, then unplug the power cord and all other cables
connected to the server.
2
Remove the bezel by unlocking it, then pulling it straight off the front of the chassis.
3
Follow the instructions in
4
Follow the instructions in
5
Remove all drives and drive carriers by following the instructions in
replacing a hard drive" on page
from.
If you are installing a hot-swap backplane for the first time, go to
go to the next step.
6
Disconnect all cables from the backplane.
82
"Preventing static electricity discharge" on page
"Opening the server case" on page
"Removing the air baffle" on page
53. Make note of which bay you remove each drive
www.gateway.com
37. Make
38.
42.
"Installing or
Step 9. Otherwise