Table of Contents
Advertisement
While holding the bracket on top of the radiator, mark the location of the mount bracket holes on the 1"x
1" tubes. Do not let the end of the bracket overhang the tube, another piece of aluminum will be
attached to the outside of the tube later (see picture below).
Remove the top mount bracket and drill through the 1"x 1" tubes at the marked locations using a
5
/
"
16
drill bit.
Attach the top radiator mount bracket using the
5
/
"x 1.5" screws, washers and locknuts.
16
Top radiator mount bolt.
Radiator Aluminum
Rivet and silicone the radiator side aluminum to the center air duct panel. The side with the semicircle
cut-out goes on the driver side.
From the secondary body fastener assembly, use some press-on weather stripping on the three top sides,
the sides that will contact the radiator, and along the lower front edge of the large radiator duct.
225
www.factoryfive.com
508-291-3443
Advertisement
Table of Contents
