Table of Contents
Advertisement
Mount the side Exhaust mount to the frame using four
Bolt through the top hole of the rubber and the frame bracket using a
Line the bottom hole up with the slot on the side exhaust and tighten the bolt.
White painted side exhaust mounted. Note the sand blasting from the front wheels on the paint.. We
suggest ceramic coating as it holds up better to this abuse.
Windshield area
Drill,
3
/
" drill bit, ⅜" wrench, ⅛" hex key
16
Windshield assembly, secondary body fasteners assembly, masking tape.
Handle the windshield with care and store in a safe place.
This is a test fit only.
Once the windshield is installed, the screws around the windshield are not accessible making the
removal of the rear part of the body impossible without the removal of the windshield.
For the final assembly after paint, a foam dam tape is used around the windshield flange on the
body. This is usually about ⅜" tall. The windshield will sit on or slightly above this in the
windshield urethane glue so that it is flush with the body.
Use the large rubber bumpers from the secondary body fasteners assembly and masking tape around the
Set the windshield in place.
Add or change the bumpers so that the windshield is flush with the body. There should be about ⅛" gap
all the way around the windshield. This can be adjusted in the next step.
3
/
" long rivets.
16
windshield opening
291
www.factoryfive.com
508-291-3443
5
/
"x 1.5" button head screw.
16
Advertisement
Table of Contents
