Headlight Covers - Factory Five Racing Type 65 Coupe Assembly Manual

Headlight Covers


Drill, ⅛" drill bit, Philips head screwdriver, masking tape, marker, ruler, and sandpaper.

Headlamp covers/fasteners
Stick masking tape around the edge of the headlight bucket so the paint will not be scratched.
Position the headlight cover in the opening with your hands as shown in the picture. Only press down at
four points on the cover. Move your fingers as necessary so that the cover is flush with the body
everywhere. If necessary use sandpaper on the edge of the plastic to shape the plastic.
Mark on the masking tape where your fingers were located.
Remove the cover.
At the points marked, measure down from the edge of the bucket ⅛" and mark the tape.
Tape four of the mounting tabs in the bucket opening at the points marked.
333
www.factoryfive.com 508-291-3443