Table of Contents
Advertisement
Final Hatch Mounting
Razor knife, ½" socket, ratchet.
Secondary body fasteners.
The rear hatch uses the weather stripping that has two legs on it, one longer than the other and has no
adhesive on the back.
Press the double stick tape around the rear hatch recess area.
Starting at the bottom in the middle, press the weather stripping onto the double stick tape with the
longer leg towards the inside of the hatch to help prevent water getting to the hatch area.
Remount the hatch by placing the glass back in the opening, set the gap around the body opening and
bolting the two halves of the hinge arms together.
Dash and Gauges
Dash
Wire stripper, wire crimping tool, electrical tape, Teflon tape, Philips head screw driver, slotted
screw driver,
5
/
16
⅞" drill bits, drill, marker, ruler.
Gauge set, aluminum cockpit assembly.
Read the instructions completely before starting. There is more than one way to run the wires for
the gauges. The method described here uses wires to form a harness to run power and ground for
the gauges. Another way is to use trailer plugs to allow easy dash removal later if necessary and
", ½",
11
/
", ¾", 1" wrenches, hack saw, solder, soldering iron, pliers,
16
www.factoryfive.com
356
508-291-3443
1
/
", ½",
8
Advertisement
Table of Contents
