Rear Spoiler - Factory Five Racing Type 65 Coupe Assembly Manual

Hold the scoops up to the body in the locations desired and sand or cut the outside of them as needed to
fit in the location. Make sure to keep about ½" of flange for the ⅛" rivets that will hold them on.
Mark the rivet locations on the scoop flanges.
Drill through both the scoops and the body/nose.

Rear Spoiler


Sandpaper, ⅛" drill bit, drill, marker.

Coupe rear spoiler.

On the original car, this was a riveted on part but some customers have had their body shops
fiberglass the spoiler into the body.
Hold the rear spoiler up to the body. Sand or cut the flange to fit or as desired.
Mark the location of the rivets.
Drill the spoiler and body for the rivets.
285
www.factoryfive.com 508-291-3443