Radiator Aluminum - Factory Five Racing Mk4 Roadster Assembly Manual

Radiator Aluminum

Drill, ¼" Nut driver, ⅛",
Secondary body fasteners, engine bay aluminum.
Use care when handling aluminum, the edges are sharp and can cut you.
The radiator and its plumbing were installed before the body was mounted. The radiator is being held
up at the bottom by a couple of zip ties through a quick jack bumper hole.
Use a floor jack under the radiator to hold it in place.
Cut and remove the zip ties.
Mark the radiator floor piece for either screws or, rivets for a cleaner look (attach every 2" if using
rivets).
Pass the radiator floor piece through the nose.
3 / " drill bits, rivet tool, floor jack, marker, ruler, silicone, caulk gun.
16
386
www.factoryfive.com 508-291-3443