Table of Contents
Advertisement
Make sure that the nose and the body sides are aligned with each other.
Look at the two splash guard pieces and move them forward or back so they are aligned.
Use a marker and tin snips or move the lower splash guard if necessary to create an even gap between
the upper and lower splash guards. Push-on weatherstrip will be used here after the pieces are located.
Put a wheel and tire on the car and check for aluminum clearance and use some tape to mark the start
location of the upper splash guard on the radiator opening and the lower splash guard on the 1"x 1" tube.
Push some of the bulb weatherstrip onto the outside of the upper splash guard from behind the radiatior
opening going around to the lower outside mount.
Apply silicone to the radiator opening and from the radiator opening side rivet through the fiberglass and
the aluminum.
Apply silicone to the bottom outside corner of the upper splashguard and rivet through the fiberglass and
the aluminum using
3
/
" rivets.
16
380
www.factoryfive.com
508-291-3443
Advertisement
Table of Contents
