Table of Contents
Advertisement
Duct tape the hooks into the holes to help in the assembly process.
Place the battery onto the tray with the positive terminal on the driver's side.
One by one, wipe clean of any grease/oil on the hook bolt. Using JB Weld or silicone, cover each hook
before they are inserted into the holes drilled for them. This will help prevent any hook from coming
out if it is not tight.
As you tighten the battery plate upward, make sure that the battery brace is lined up with the depression
on the battery and make sure the battery is straight.
Tighten the battery down until it is snug against the frame and does not move. Do not over tighten and
bow the sides of the battery causing damage to the battery. The bolts should be tightened evenly and
none should be loose.
Battery Cables
⅜", ½" socket, ¼",
Engine ground cable assembly, OEM braided ground strap, engine/harness assembly, insulated
line clip assembly, misc. electrical assembly.
Do not connect the battery yet. Leave the cable zip tied. The cable will need to be run through
the trunk floor later.
Run the battery cable from the positive terminal of the battery straight forward, down the driver's side of
the transmission tunnel. Zip tie as you go.
Battery tray mounted in rear trunk corner for fuel cell.
5
/
" drill bit, drill,
3
/
16
16
www.factoryfive.com
" Hex key, marker, tin snips/razor, sand paper.
201
508-291-3443
Advertisement
Table of Contents
