Driveshaft - Factory Five Racing Type 65 Coupe Assembly Manual

Tighten the transmission mount to the frame.

Driveshaft


14mm wrench, thread locker

Mustang driveshaft and fasteners
If not already done, the driveshaft should be shortened to the length specified in the appendix for the
engine/transmission combination being used.
Slip the shortened driveshaft up into the rear of the transmission. The most room to do this is usually to
hold the shaft just above the center section and come in from the driver's side.
209
www.factoryfive.com 508-291-3443