Table of Contents
Advertisement
Thread the cut rear springs onto the conical frame mounts all the way.
Insert the cut rubber spring mount between the spring and the steel seat. Make sure the end of it is flush
with the end of the spring mount.
Suspension height adjustments are done in the rear by turning the spring from its normal position
on the mount to a position higher or lower. Remember that the spring is located halfway to the
arm mount, so any height changes at the spring will be multiplied by roughly two at the axle.
4 Link Rear Suspension
18mm sockets, ratchet, 15mm wrench
Mustang upper control arms and hardware.
Attach the Mustang upper rear control arms loosely to the rear end using the Mustang hardware.
Skip the 3 Link section and continue on with the rear axle section.
Optional 3 Link Rear Suspension
3
/
", ⅜", ½" drill bits, ⅝", ¾",
16
Ratchet, Torque Wrench, Drill, Ruler/Tape measure, Pliers, Flat head Screwdriver, Tin
Snips/scissors/razor, Marker.
3-Link rear suspension with kit.
15
/
", 1" wrenches, ⅜", ⅝", ¾",
16
87
www.factoryfive.com
508-291-3443
15
/
" sockets,
5
/
" Hex key,
16
16
Advertisement
Table of Contents
