Emergency Brake Handle - Factory Five Racing Type 65 Coupe Assembly Manual

If you are using a Lakewood bell housing, trim the area around the starter so that is flush with the
inspection cover.
If you are not running emissions equipment, the only engine controls that need vacuum are the PCV
valve in the valve cover and the fuel pressure regulator. The EGR can be left unhooked. Make sure to
close off any extra vacuum ports.
If you are not running emissions equipment, the hoses, mounts and solenoids can be removed.
Install the headers using the header originally for the left side on the right side of the engine, and the
right header on the left side of the engine. Thread all of the bolts on the headers before tightening any of
them, to make installation easier.

Emergency Brake Handle


Grinder, scissors

Refer to appendix for the emergency brake handle diagram.
Cut the diagram in Appendix A out with scissors and mark where the emergency brake handle needs to
be cut. This is done so that the passenger seat will not rub up against the back part of the emergency
brake handle.
48
www.factoryfive.com 508-291-3443