Rear Wall - Factory Five Racing Type 65 Coupe Assembly Manual

Rear Wall


1 / " drill bit, silicone, rivet gun, caulk gun,
8

Mounted Aluminum, Packaged Aluminum, secondary body fasteners
Position the panel on the frame overlapping the side wall tabs.
Mark where the rivets will go by tracing around the tubes the same way previously done.
Remove the panel and apply silicone to the frame and side wall tabs.
Attach the panel with #6 self-tapping screws.
Rivet the panel in place.
9 / " wrench,
16
203
www.factoryfive.com 508-291-3443
5 / " hex key.
16