Factory Five Racing Type 65 Coupe Assembly Manual page 66

Install the snap ring on the spring hat so that it holds onto the shock end. Make sure that the slot in the
snap ring and the slot in the spring hat are not aligned.
Pass the shock assembly (with the body of the shock up) through the upper control arm and attach
them to the lower control arm using the 0.43" spacers that are supplied in the kit.
Check for shock clearance on brake lines, emergency brake cables, brake calipers, frame and axle parts.
Check to make sure that the spring is seated correctly on the shock.
Run zip ties through the holes in the spring hat and around the spring to prevent the spring from
becoming unseated.
65
www.factoryfive.com 508-291-3443