Table of Contents
Advertisement
Raise or lower the front of the nose so that the bottom edge of the hood is parallel with the bottom edge
of the body above the exhaust area.
Align the rear of the wheel well of the nose with the front of the body.
Move the nose around so there is a small gap (i.e. ⅛") along the backside of the nose against the rear
body clip and along the bottom edge of the nose. Use wood or washers in the gap to keep it consistent.
The hood has been trimmed slightly oversized to allow the panel gaps to be sanded down to fit.
Trim the rear edge of the nose with a sander or saw so that the gap is consistent.
279
www.factoryfive.com
508-291-3443
Advertisement
Table of Contents
