Customizing Settings For Recorded Video - Honeywell Rapid Eye Administrator's Manual

Customizing Settings for Recorded Video

Document 800-02953V4 Rev A
03/10
Note Remember to enable recording on all cameras, especially those where
alarms are expected. If recording is not enabled, no alarm video will be
recorded when the alarms are set off.
Feedback on the Video tab
On the Video tab, note that a red dot has appeared, between the camera's icon and its
name ( ). The dot means that the unit is recording the video feed.
Turning Recording OFF
Camera settings are retained when recording is turned OFF.
Caution Disabling a camera resets the recording settings and other configurations
to default settings. The defaults are used when the camera is re-enabled.
Flexibility
Use the Recording tab to customize a Resolution, Frame Rate and Quality for each
camera's Continuous recording and Event recording settings. The recording settings can
be the same for all cameras or customized on a camera-by-camera basis.
Making Settings
Values for Event recording cannot be set lower than the settings for Continuous recording.
Forecasting Results
For Calculating the Length of the Video
settings, see Comparing the Resolutions of Recorded
Rapid Eye Multi-Media DVR System Administrator Guide
Archive, see page
Video, page 87.
134. To compare resolution
79