Using Admin And View To Create A User Account - Honeywell Rapid Eye Administrator's Manual

Using Admin and View to Create a User Account

Document 800-02953V4 Rev A
03/10
Result
The next time that you update the site using the Admin application, the label next to the
Change button reads Central User Management is in effect.
The accounts of users authorized to operate the unit are copied to the unit and replace the
accounts created locally. Operators with accounts that authorize operation of the unit, can
access that unit either offsite using View, or locally using LocalView.
Notification of an Admin and Localview Problem
After a Multi SA has used Admin to select Central user management and View to run a
Maintenance Session (as explained above), the LocalView Administrator can select Local
user management. The next time that the Multi SA runs a
indicates that there is a discrepancy in the User Management settings. The Multi SA has the
option of setting User Management to Central or of leaving it on Local.
Whether user management is central or local, Admin is used to create accounts for
operating units from a PC running the View application.
1. Using Admin, click the Users tab.
2. To display the Add User dialog box, do one of the following:
• Click on the toolbar.
• Click Add on the Actions menu.
Ctrl Ins
• Press + .
3. Enter a name in the User name field (see the example in
asked to use another name if the name you entered is already being used in your
system.
4. Click Save and Close.
Naming Restrictions
For user account names, do not use:
• The database name of the Multi db. A user account with the same name as the Multi
central database causes an error when a copy of the database is made locally.
• Self or (self). A phrase used by some Multi reports.
• Administrator. This account name is reserved.
Rapid Eye Multi-Media DVR System Administrator Guide
Maintenance Session, a message
Figure 9-2). You will be
171