Dhcp Reference; Figure 3-5 Report Of A Dynamic Ip Assigned By Dhcp To A Rapid Eye Unit - Honeywell Rapid Eye Administrator's Manual

DHCP Reference

Document 800-02953V4 Rev A
03/10
1. Use LocalView to enable DHCP on the Rapid Eye unit (see
is not used in this type of connection.
2. Click Refresh.
3. Make a note of the IP Address assigned by DHCP to the unit. The IP Address is
needed for use in step 4
4. Using Admin, add a connection as you would for a
IP Address field, enter the IP Address used in LocalView, obtained in
5. Contact the administrator of your network to reserve the IP address obtained in
step 3. DHCP can change an address if it is not reserved, compromising future
attempts to connect to the unit.
Timeout on Network without DHCP
If DHCP is unavailable on your network, a unit's request for DHCP services times-out after
two minutes.
DNS Registration
The DNS registration of DHCP leases is made with the DNS specified by the DHCP server,
and network card properties. Contact your organization's Network administrator to obtain
the proper primary DNS entry for your local client if the name is not resolved.
Leased IP Address
To see the IP address that DHCP leased to the unit, use View to run a
and then click the System tab. See
Figure 3-5 Report of a Dynamic IP Assigned by DHCP to a Rapid Eye Unit
Rapid Eye Multi-Media DVR System Administrator Guide
and step 5 of this procedure.
Common
Figure 3-5.
IP address
assigned to
the unit by
DHCP
Figure 3-3). The Site Name
Network, page 43. In the
step 3.
Maintenance Session,
45