External Hardware Control Of A Public Display Monitor; Figure 8-8 Monitor Out Tab, For A Unit's Monitor Output 1 - Honeywell Rapid Eye Administrator's Manual

Configuring Other Hardware

External Hardware Control of a Public Display Monitor

156
6. Enter a number in the Duration box. The number sets the amount of time (in
seconds) that the video feed is displayed on the monitor. If only one camera is listed,
the duration is ignored and the feed is continuously displayed. When many cameras
are listed, the monitor sequences through them for the time specified. You have the
option of changing the duration directly in the list by selecting it and entering another
value.
7. Click Add. Repeat step
camera can be included multiple times in the same tour.
Color Bars
On Multi-Media DSP units, the MONITOR OUTPUT 1 connector on the back of the
Multi-Media unit cannot produce a test pattern. For these units, the Color Bars option is not
available, on the Monitor Out tab of a
You can connect a third-party hardware switch to a Multi-Media unit. The switch can freeze
a public display monitor and control whether the next camera or previous camera is
monitored. For wiring details, see
hardware control of a public display monitor:
1. Using View, continue or start a
explained in Maintenance Session
2. Click the Monitor Out tab.
3. Enable the Enable External Control checkbox (see
Multi-Media unit's General Purpose Inputs 13, 14 and 15 for switch use.
Figure 8-8 Monitor Out Tab, for a Unit's Monitor Output 1
5, to step 7 to add more video feeds to the public monitor. A
Maintenance Session.
Table 8-6 and the switch documentation. To enable local
Maintenance Session
on page 61).
for the Rapid Eye site (as
Figure 8-8). This reserves a