Common Network; Dynamic Host Configuration Protocol; Figure 3-2 Setting-Up A Common Network Connection - Honeywell Rapid Eye Administrator's Manual

Common Network

Select to use the
existing network
connection and enter
the static IP address
provided by your
network administrator

Dynamic Host Configuration Protocol

Document 800-02953V4 Rev A
03/10
Use a common network connection on a network without DHCP. For DHCP, see
Host Configuration Protocol
Figure 3-2 Setting-Up a Common Network Connection
While Working with Connections (page
1. In the Add Connection window, click Use Existing Network Connection (see
Figure 3-2).
2. In the IP Address field, enter the static IP address that was assigned to the unit by
your network administrator or installer.
3. You have the option of entering a Connection Name, to rename the connection.
4. Click Save and Close. For a report, see
Note To set Network Settings using LocalView, ensure that no one is running a
remote Maintenance Session
Rapid Eye Active Alert units that run V8.1 or older V9 software can ONLY
access network settings on LocalView. Rapid Eye DVRs with the latest V9
software have full LocalView access. Download the latest software at
www.honeywellvideo.com/support/downloads/downloads_dvr.html.
Use of DHCP with DNS is assumed. For DHCP without DNS, see
1. Use LocalView to enable DHCP on the Rapid Eye unit. See
By default, the Site Name in LocalView shows REM[hyphen][unit serial
number] and includes the leading zeroes. The unit serial number of the Rapid Eye
unit is also printed on a sticker affixed to the unit.
Rapid Eye Multi-Media DVR System Administrator Guide
on page 43.
41):
Connection Report
on the unit.
Dynamic
on page 56.
page 44.
Figure 3-3.
43