Setting The System Clock Manually; Adjusting The Clock On A Pc Running Rapid Eye Software; Using A Pc Clock To Set A Unit Clock Manually - Honeywell Rapid Eye Administrator's Manual

Setting the System Clock Manually

TIP!

Adjusting the Clock on a PC Running Rapid Eye Software

Using a PC Clock to Set a Unit Clock Manually

Document 800-02953V4 Rev A
03/10
8. You have the option of either ending the maintenance session or continuing to
configure the unit. See
Auto-Synch Statistics
The statistics that appear are for Multi technical support, if they make a service call to your
site. The Auto-synch statistics do not apply to a clock set to Manual.
Last Synchronized at shows the last time that the SNTP server was used. Synchronization
to SNTP occurs at least every 24 hours.
Time Difference displays the accuracy of synchronization.
A Multi SA can synchronize the clock of a Rapid Eye Multi-Media unit using a PC's clock as
reference. This is more useful for units connected only by dial-up, but can also be used for
units on a LAN.
Check/set the clock on an operator's PC before setting a unit clock manually.
To adjust the PC time, date and time zone:

1. Click Start Control Panel
2. Check the accuracy of the time and the time zone on the PC and adjust it as needed.
1. Using the View application, select a Multi-Media unit whose clock needs to be set.
2. Start a Maintenance Session.
3. Click the Time tab. If Manual is not selected, click it. The Time tab appears as in
Figure 4-4.
4. Click Set Multi unit's clock.
Rapid Eye Multi-Media DVR System Administrator Guide
Ending Maintenance on page 71.

Date and Time.
67