Assigning And Setting A Ptz Device; Hardware Report; Using Monitor Output 1 As A Public Display Monitor - Honeywell Rapid Eye Administrator's Manual

Assigning and Setting a PTZ Device

Hardware Report

Using Monitor Output 1 as a Public Display Monitor

Document 800-02953V4 Rev A
03/10
1. Consult the installer to find out which serial port of the unit the PTZ cameras are
connected to. If more than one PTZ camera shares the same serial communications
line, make a note of the address set on each camera.
2. Continue or start a Maintenance Session
3. Click the Serial Devices tab. A PTZ device is either:
• Assigned to a Port. Click PTZ. The settings are displayed and can be changed.
• In the Unassigned Devices group. Click PTZ. The settings are displayed and can
be changed.
• In the New Devices group. Drag the PTZ icon and drop it either on the
Unassigned Devices group or on a Port. If you drop it on a port that is already
assigned to another device, the PTZ device replaces it. The displaced device is
sent to the Unassigned Devices group.
4. Change the values to those suggested by the PTZ camera documentation.
5. Drag the modem icon to the port icon with the number of the port identified in
During a Maintenance Session
includes a serial number of the Multi-Media unit on the Rapid Eye site, the version of
software running the Multi-Media unit, the date of manufacture, and internal hardware used
by the unit.
A public display monitor can be set up independently of LocalView, on Multi-Media and
Multi-Media LT units. There is no need for converters between the monitor and the
Multi-Media unit.
1. Mount a monitor where you plan to have it display a video feed. For NTSC cameras,
use an NTSC video monitor; for PAL cameras, use a PAL monitor.
2. Connect a coaxial cable to the INPUT connector on the video monitor.
3. Connect the other end of the coaxial cable to MONITOR OUTPUT 1, on the back of
the Multi-Media unit (or Multi-Media LT unit).
4. Using View, continue or start a
Monitor Out tab.
5. Select a camera that will be seen on the monitor in the Cameras to Choose from box
(see Figure 8-8).
Rapid Eye Multi-Media DVR System Administrator Guide
for the Rapid Eye site.
for the Rapid Eye site, click the Hardware tab. The report
Maintenance Session
step
for the Rapid Eye site. Click the
1.
155