Central User Management; Setting A Unit To Central User Management; Figure 9-1 Changing User Management - Honeywell Rapid Eye Administrator's Manual

Managing User Accounts

Central User Management

Click to change
the local user
management

Setting a Unit to Central User Management

170
Setting Local User Management
A LocalView administrator has the option of setting User Management to Local. Accounts
that were created centrally will remain on the unit.
Creating Accounts Using Admin
Central User Management only disables the onsite creation of operator accounts using
LocalView. If Central User Management is enabled, a Multi SA uses the Admin application
to create accounts. These central accounts can access Multi-Media units using the View
application or LocalView.
Figure 9-1 Changing User Management
1. While using Admin to update (or create) a site's definition, click the Change button
next to Local User Management is in effect (see
to confirm setting the site to central user management. After clicking Yes, the
message next to the button changes to Central User Management is
pending.
2. Use View to run a Maintenance Session
3. Click Update Security. The procedure to update security is shown in
Security on a Multi-Media
Figure
at the site. Click the Security tab.
Unit, page 143.
9-1). A dialog box appears
Updating