Common Network; Dynamic Host Configuration Protocol Using Dns; Figure 2-9 Localview Panel For Network Settings; Figure 2-10 Localview Network Settings With Dhcp - Honeywell Rapid Eye Installation Manual

Common Network

Dynamic Host Configuration Protocol Using DNS

Document 800-02607V3 Rev A
11/09
Figure 2-9 LocalView Panel for Network Settings
164.178.32.1
1. Using LocalView, enter the IP Address of the DVR (see
the virtual keyboard (see
Address and click OK.
2. Click Enter.
Figure 2-10 LocalView Network Settings with DHCP
1. In Network Settings, enable DHCP on the Rapid Eye DVR (see
By default, the Site Name in LocalView shows REM[hyphen][DVR serial
number] and includes the leading zeroes. The DVR serial number is also printed on a
sticker affixed to the DVR.
If you change the Site Name, make a note of the new name, for setting up a remote
connection using the Admin software.
2. Click Refresh.
Rapid Eye™ Multi-Media DVR Installation Guide
If you are not using Dynamic
Host Configuration Protocol
(DHCP), enter the IP Address
for your unit manually.
Figure 2-8). Click the keyboard buttons to enter the IP
If you are using Dynamic Host
Configuration Protocol (DHCP) to
assign an IP Address for your unit,
select the Use DHCP check box.
Figure 2-9). Click to open
Figure 2-10).
35