Common Network; Dynamic Host Configuration Protocol Using Dns; Figure 2-7 Localview Panel For Network Settings; Figure 2-8 Localview Network Settings With Dhcp - Honeywell Rapid Eye Hybrid LT Installation Manual

Common Network

Dynamic Host Configuration Protocol Using DNS

Document 800-07766V4 Rev A
01/2013
Figure 2-7 LocalView Panel for Network Settings
If you are not using Dynamic Host Configuration Protocol (DHCP), enter the IP Address for
your unit manually:
1. Using LocalView, enter the IP Address of the DVR (see
the virtual keyboard (see
Address and click OK.
2. Click Enter.
Figure 2-8 LocalView Network Settings with DHCP
If you are using Dynamic Host Configuration Protocol (DHCP) to assign an IP Address for
your unit, select the Use DHCP check box:
1. In Network Settings, enable DHCP on the Rapid Eye Hybrid LT unit (see
By default, the Site Name in LocalView shows REM[hyphen][DVR serial
number] and includes the leading zeroes. The DVR serial number is also printed on a
sticker affixed to the DVR.
If you change the Site Name, make a note of the new name, for setting up a remote
connection using the Admin software.
2. Click Refresh.
Rapid Eye™ Hybrid LT DVR Installation Guide
Figure 2-6). Click the keyboard buttons to enter the IP
Figure 2-7). Click to open
Figure 2-8).
37