Replacing The Front Operator Panel Assembly - IBM System x3850 X6 Installation And Service Manual

Replacing the front operator panel assembly

Use this information for instructions on how to replace the front operator panel.
About this task
To install the front operator panel, complete the following steps.
Procedure
1. Reinstall the LCD system information display panel into the front operator
2. Orient the LCD system information display panel so that the LCD connect is
3. Lower the LCD system information display panel, while aligning the LCD
4. Reconnect the LCD display panel cable to the LCD display panel.
5. Align the front operator panel with the slot on the storage book and slide it in
272
System x3850 X6 and x3950 X6 Types 3837 and 3839: Installation and Service Guide
panel.
next to the LEDs on the operator panel.
retention latch with the slots on the front operator panel. Push it in until it
clicks in place on the front operator panel.
until it is seated in place.
LCD/Operator
panel
Release
latch