IBM System x3850 X6 Installation And Service Manual page 928

806f032b-2101ffff • 806f040c-2581ffff
806f032b-2101ffff A firmware or software incompatibility was detected on system
[ComputerSystemElementName].
Explanation: A mismatch of IMM firmware between nodes has been detected.
May also be shown as 806f032b2101ffff or 0x806f032b2101ffff
Severity: Error
Alert Category: Critical - Hardware Incompatibility
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0442
SNMP Trap ID: 36
Automatically notify Support: No
User response: Attempt to flash the IMM firmware to the same level on all nodes.
806f032b-2e01ffff A firmware or software incompatibility was detected on system
[ComputerSystemElementName].
Explanation: FPGA firmware has booted to back up. FPGA has a failure either during a firmware flash or has been
corrupted.
May also be shown as 806f032b2e01ffff or 0x806f032b2e01ffff
Severity: Error
Alert Category: Critical - Hardware Incompatibility
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0442
SNMP Trap ID: 36
Automatically notify Support: No
User response: The system board needs to be replaced. :
806f040c-2581ffff [PhysicalMemoryElementName] Disabled on Subsystem [MemoryElementName].
Explanation: IMM has reported that Memory has been Disabled.
May also be shown as 806f040c2581ffff or 0x806f040c2581ffff
Severity: Info
Alert Category: System - Other
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0131
SNMP Trap ID:
Automatically notify Support: No
User response: This is a UEFI detected event. The UEFI diagnostic code for this event can be found in the logged
IMM message text. Please refer to the UEFI diagnostic code in the "UEFI diagnostic code" section of the Info Center
for the appropriate user response.
Related Links:
"Finding the UEFI (POST) error code" on page 1666
v
910
System x3850 X6 and x3950 X6 Types 3837 and 3839: Installation and Service Guide