Replacing The System Battery - IBM System x3850 X6 Installation And Service Manual

3. Remove the standard I/O book from the server (see "Removing the standard
I/O book" on page 221).
4. Remove the battery from the standard I/O book board:
a. Use one finger to push the battery horizontally out of its housing.
b. Use your thumb and index finger to lift the battery from the socket.
5. Dispose of the battery as required by local ordinances or regulations. See the
IBM Environmental Notices and User's Guide on the IBM Documentation CD for
more information.

Replacing the system battery

User this information for instructions on how to replace the system battery.
About this task
The following notes describe information that you must consider when replacing
the system battery in the standard I/O book.
v When replacing the battery on the standard I/O book board, you must replace it
with a lithium battery of the same type from the same manufacturer.
v To order replacement batteries, call 1-800-426-7378 within the United States, and
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada,
call your IBM marketing representative or authorized reseller.
v After you replace the battery on the standard I/O book board, you must
reconfigure the server and reset the system date and time.
v To avoid possible danger, read and follow the following safety statement.
Statement 2
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has a
module containing a lithium battery, replace it only with the same module type
made by the same manufacturer. The battery contains lithium and can explode if
not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Chapter 6. Removing and replacing components
263