IBM System x3850 X6 Installation And Service Manual page 87

Table 21. Installation sequence for the eight compute books configuration for an 8-socket server
Compute Top node
book (bay 1)
1 compute
book 1
2
3
4
5
6
7
8
v For more information about the DDR3 compute book, see "DDR3 compute
v For a list of supported devices, see http://www.ibm.com/systems/info/
To install the DDR3 compute book, complete the following steps:
Procedure
1. Read the safety information that begins on page "Safety" on page vii and
2. Turn off the server (see "Turning off the server" on page 41) and all attached
3.
4. Remove the compute book cover(s) to install your DIMMs (see "Removing the
5. Install your DIMMs (see "Installing a memory module" on page 47).
6. Open the cam handle on the compute book. Pull the top fan-pack handle down
7. Align the DDR3 compute book with the bay on the server and slide it in the
Top node Top node
(bay 2) (bay 3)
compute
book 2
compute
book 3
book" on page 30. For more information about installing DIMMs, see "Installing
a memory module" on page 47.
x86servers/serverproven/compat/us/.
"Installation guidelines" on page 45.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
DDR3 compute book cover" on page 218).
and slide the blue release latch (behind the fan handle) to the right to release
the DDR3 compute book cam handle.
server. Place one hand under the center of the compute book to support it
while sliding it into the server.
Top node Bottom
(bay 4) node (bay 1)
compute
book 4
compute
book 5
Bottom Bottom
node (bay 2) node (bay 3)
compute
book 6
compute
book 7
Chapter 2. Installing optional devices
Bottom
node (bay 4)
compute
book 8
69