IBM System x3850 X6 Installation And Service Manual page 717

806f010d-0405ffff The [NumericSensorElementName] has been disabled due to a detected fault.
Explanation: The drive 5 has been disabled (defunct) due to a fault detected by the controller.
May also be shown as 806f010d0405ffff or 0x806f010d0405ffff
Severity: Error
Alert Category: Critical - Hard Disk drive
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0164
SNMP Trap ID: 5
Automatically notify Support: Yes
User response:
1. Check IBM Support site for Service Bulletins/RETAIN tips related to your particular drive.
2. Check IBM Support site for firmware updates related to your particular drive.
3. Check for any other RAID related errors.
4. Replace the drive.
Related Links:
"Removing 2.5-inch and 1.8-inch hot-swap drives" on page 231
v
"Replacing 2.5-inch and 1.8-inch hot-swap drives" on page 232
v
806f010d-0406ffff The [NumericSensorElementName] has been disabled due to a detected fault.
Explanation: The drive 6 has been disabled (defunct) due to a fault detected by the controller.
May also be shown as 806f010d0406ffff or 0x806f010d0406ffff
Severity: Error
Alert Category: Critical - Hard Disk drive
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0164
SNMP Trap ID: 5
Automatically notify Support: Yes
User response:
1. Check IBM Support site for Service Bulletins/RETAIN tips related to your particular drive.
2. Check IBM Support site for firmware updates related to your particular drive.
3. Check for any other RAID related errors.
4. Replace the drive.
Related Links:
"Removing 2.5-inch and 1.8-inch hot-swap drives" on page 231
v
"Replacing 2.5-inch and 1.8-inch hot-swap drives" on page 232
v
806f010d-0405ffff • 806f010d-0406ffff
Appendix B. Integrated management module II (IMM2) error messages
699