Removing The Half-Length I/O Book - IBM System x3850 X6 Installation And Service Manual

Removing the half-length I/O book

This information provides instructions for removing the half-length I/O book.
About this task
To remove the half-length I/O book, complete the following steps:
Procedure
1. Read the safety information and installation guidelines, see "Safety" on page vii
2. The half-length I/O book is hot-swappable if no adapters are installed in the
3. Remove any external cables that are attached to the adapters.
4. Press the blue release latch downward; then, rotate the handle all the way
5. Open the adapter retention latch.
6. Remove the adapters from the I/O book (see "Removing an adapter" on page
Results
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 119.
226
System x3850 X6 and x3950 X6 Types 3837 and 3839: Installation and Service Guide
and "Installation guidelines" on page 45.
I/O book. If adapters are installed in the I/O book, you must first press the
Power button on the I/O book (or via the operating system) and power-off all
three PCIe adapter slots before you remove the I/O book from the server. The
slots LED lights will be off when the slots are off-line.
down and slide the I/O book out of the server.
230).