IBM System x3850 X6 Installation And Service Manual page 109

Table 27. Supported ML2 (Ethernet) adapters and where you can install the adapters. (continued)
Ethernet adapters
Broadcom NetXtremeII ML2
dual-port 10 Gb-T Ethernet
Adapter for IBM System x
Broadcom NetXtremeII ML2
dual-port 10 Gb-SFP+ Ethernet
Adapter for IBM System x
Where to install the
adapter Notes and Features
This adapter can only
v Port 1 on the adapter is the default port for IMM Shared
be installed in slot 10
mode when enabled through UEFI.
on the standard I/O
v This adapter provides the following features:
book board.
– PCIe Gen2 x8 dual-port 10 Gb Base-T controller in 50
– TCP/IP Offload (TOE), Wake on LAN (WOL), UCM
– Supports standard pNIC or vNIC2 modes
– Unified networking delivering LAN and iSCSI over 10
– Two independent 10 Gbp Base-T interfaces with
– PCI Express v2.1 with support for x8 link width 10 Gb
– DMTV Network Controller Sideband interface (NC-SI)
This adapter can only
v Port 1 on the adapter is the default port for IMM Shared
be installed in slot 10
mode when enabled through UEFI.
on the standard I/O
v This adapter provides the following features:
book board.
– PCIe Gen2 x8 dual-port 10 Gb SFP+ controller in 50
– TCP/IP Offload (TOE), Wake on LAN (WoL), UCM
– Supports standard pNIC or vNIC2 modes
– Unified networking delivering LAN and iSCSI over 10
– Two independent 10 Gbp SFP+ interfaces with SR-IOV
– PCI Express v2.1 with support for x8 link width,
– DMTV Network Controller Sideband interface (NC-SI)
mm wide ML2 form factor
and CIM capable
Gb Base-T
SR-IOV capability
Base-T and 1000Base-T link modes
capable for IMM2 shared port access
mm wide ML2 form factor
and CIM capable
Gb SFP+
capability
accepts both FTP+ SR optical and SFP+ DAC cables
capable for IMM2 shared port access
Chapter 2. Installing optional devices
91