Installing The 4X2.5-Inch Hot-Swap Drive Backplane - IBM System x3850 X6 Installation And Service Manual

10. Connect the SAS/SATA signal cables to the drive backplane and to the
Results
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 119.

Installing the 4x2.5-inch hot-swap drive backplane

Use this information for instructions on how to install the 4x2.5-inch hot-swap
drive backplane assembly.
116
System x3850 X6 and x3950 X6 Types 3837 and 3839: Installation and Service Guide
8x1.8-inch
drive filler
Drive
LEDs
8x1.8-inch
drive backplane
assembly
8. Slide the drive backplane assembly into the backplane bay until it clicks into
place.
9. Connect the power cable to the power connector on the drive backplane
assembly (one end of the power cable is connected to the rear of the storage
book).
Note: If the cables are not connected correctly, when the server is powered on
the LEDs on all drives in the backplane will be lit, indicating a configuration
error.
adapter.
Storage book