Local Network - Dhcp Server - NetComm NB6 User Manual

Key in the subnet mask that you received from your ISP for the LAN connection.
Host Name:
List the host name of this device.
Domain Name:
List the name of the domain.
Configure the secondary IP Address and Subnet Mask:
Check this box to enter another set of IP Address and Subnet Mask to connect to your router if they are
not included in the range that DHCP server accepts.
After checking this box, the secondary IP address and subnet mask entries will show up, as shown
below.
Secondary IP Address & Subnet Mask:
Enter the information provided by your ISP for your LAN connection.
MTU:
It means the maximum size of the packet that can be transmitted in the network. A packet of data
greater than the number set here will be divided into several packets for transmitting. Type the value
into the field of MTU. The default setting for LAN configuration is 1500.
Apply:
Click this button to activate the settings listed above.
Local Network – DHCP Server
This allows you to set DHCP server on LAN interface.
DHCP Server On:
Check this item if DHCP service is needed on the LAN. The router will assign IP address and gateway
address for each of your PCs.