For Windows 2000; For Windows Xp/Vista/7 - NetComm NB6 User Manual
Netcomm gateway series adsl2+ modem routers yml854rev2
Hide thumbs
Also See for NB6:
- User manual (152 pages) ,
- Quick start manual (13 pages) ,
- Specification sheet (2 pages)
Table of Contents
Advertisement
Option 2: If you have TCP/IP Protocol installed, skip to Step 7.
4.
Highlight TCP/IP Protocol and click OK.
5.
Insert the Windows NT CD into your CD-ROM drive and type the location of the CD. Then click
Continue.
6.
When returning to the Network window. Open the Protocols tab, then select TCP/IP Protocol
and click Properties.
7.
Enable Obtain an IP address from a DHCP server and click OK.
8.
When prompted with the message below, click Yes to continue.
9.
When returning to Network window, click Close.
10.
When prompted with Network Settings Change dialog box, click Yes to restart your computer.
For Windows 2000
1.
From the Start menu, point to Settings and then click Network and Dial-up Connections.
2.
Right-click the Local Area Connection icon and then click Properties.
3.
On the General tab, check out the list of installed network components.
Option 1: If there is no TCP/IP Protocol, click Install.
Option 2: If you have TCP/IP Protocol, skip to Step 6.
4.
Highlight Protocol and then click Add.
5.
Click Internet Protocol (TCP/IP) and then click OK.
6.
When returning to the Local Area Connection Properties window, highlight Internet Protocol
(TCP/IP) and then click Properties.
7.
Under the General tab, enable Obtain an IP address automatically. Then click OK.
Mac OSX 10.4
1.
Click the Apple icon and choose on "System Preferences".
2.
Click on "Network" icon.
3.
Set "Location" to "Automatic and "Show" to "Built In Ethernet".
4.
Click on "TCP/IP" tab.
5.
In the "Configure" option, choose "Use DHCP with automatic address".
6.
Click on "Apply Now".
For Windows XP/Vista/7
1.
Open the Start menu, and select Control Panel.
Advertisement
Table of Contents
Troubleshooting
