Table of Contents
Advertisement
7.1
Local Area Network (LAN)
This screen allows you to configure the Local Area Network (LAN) interface on your Router.
See the field descriptions below for more details.
Option
IP Address
Subnet Mask
Enable UPnP
Enable Internet Group
Management Protocol
(IGMP) Snooping
Dynamic Host
Configuration Protocol
(DHCP) Server
Configure a second IP address by ticking the checkbox shown below and enter the following information:
IP Address:
Enter the secondary IP address for the LAN interface.
Subnet Mask:
Enter the secondary subnet mask for the LAN interface.
NOTE:
The Save button saves new settings to allow continued configuration, while the Save/Reboot button not only saves new settings
but also reboots the device to apply the new configuration (i.e. all new settings).
Description
Enter the IP address for the LAN interface
Enter the subnet mask for the LAN interface
Tick the box to enable Universal Plug and Play
Enable by ticking the box
Standard Mode: In standard mode, multicast traffic will flood to all bridge ports when
no client subscribes to a multicast group.
Blocking Mode: In blocking mode, the multicast data traffic will be blocked. When
there are no client subscriptions to a multicast group, it will not flood to the bridge ports.
Select Enable DHCP server and enter your starting and ending IP addresses and
the lease time. This setting configures the router to automatically assign IP, default
gateway and DNS server addresses to every DHCP client on your LAN
3G9W - HSPA 7.2Mbps Wi-Fi Router USER GUIDE
YML902 – 45
Advertisement
Table of Contents
