Choose PPPoA or PPPoE and click Next.
On this screen, you have to make the settings for WAN IP. To get the IP address automatically, click the
Obtain an IP address automatically button. Or click Use the following IP address button and enter the
IP address for WAN interface.
Check Enable NAT if you need.
MTU:
It means the maximum size of the packet that can be transmitted in the network. A packet of
data greater than the value set here will be divided into several packets for transmitting.
Type the value into the field of MTU. The default MTU value for PPPoE is 1492; while for
PPPoA is 1500.
Click "Next" for the next procedure.
PPP Username & PPP Password:
Key in the username and password, that you received from your ISP. (e.g., hpotter/hogwarts)
Always On:
Select this item to make the connection active all the time.
Dial on Demand:
Select this item to make a connection automatically while in demand. Enter the timeout to cut off the
network connection if there is no activity for this router.
Manually Connect:
Select this item to make a connection by pressing the Connect hyperlink on the Advanced Setup-
Internet-Connections web page.