Ppp Over Ethernet (Pppoe) Ip Extension; Mode - NetComm NB6 User Manual
Netcomm gateway series adsl2+ modem routers yml854rev2
Hide thumbs
Also See for NB6:
- User manual (152 pages) ,
- Quick start manual (13 pages) ,
- Specification sheet (2 pages)
Table of Contents
Advertisement
•
VPI – 8
•
VCI – 35
Click the Next button.
3.
On the Configure Internet Connection – Connection Type page, select PPP over Ethernet
(PPPoE) then click the Next button.
4.
On the WAN IP Settings page, select "Obtain an IP address automatically" and check Enable
NAT box. Click Next.
5.
On the PPP Username and Password page, enter the PPP username and password that you
got from your ISP. Select "Always on" or select "Dial on Demand" and key in the inactivity
timeout value. (The default value is 20 minutes.) Then click "Next".
6.
On the Configure LAN side Settings page, key in the IP address and subnet mask for your LAN,
e.g.:
Primary IP address: 192.168.1.1
Subnet Mask: 255.255.255.0
Check DHCP Server on box. And key in the start and end IP address, e.g.:
Start IP Address: 192.168.1.2
End IP Address: 192.168.1.254
Then enter the leased time (the default is 1 day), and click Next.
7.
Check the network information on This Internet Connection -- Summary page. Make sure the
settings match the information provided by your ISP. Click Finish.
PPP over Ethernet (PPPoE) IP Extension Mode
Description:
In this deployment environment, the PPPoE session is between the ADSL WAN interface and BRAS. The
ADSL Router acts as a bridge and gets a public IP address from BRAS for your computer. And only the
one that got the public IP address is allowed to access into Internet. The real IP that you got is acquired
from ISP. Moreover, no NAT translation will be done at this case.
Configuration:
1.
Start your browser and type 192.168.1.1 in the URL box to access ADSL web-based manager.
2.
Go to Advanced – Internet – Connections. And click Add.
3.
Key in the VCI and VPI value, e.g.:
•
VPI – 8
•
VCI – 35
Click the Next button.
4.
On the Configure Internet Connection – Connection Type page, select PPP over Ethernet
(PPPoE) then click the Next button.
5.
On the WAN IP Settings page, select Obtain an IP address automatically, check PPP IP
extension (and Enable NAT would become disabled automatically) then click "Next".
Advertisement
Table of Contents
Troubleshooting
