Bridge Mode; Contents - NetComm NB6 User Manual

3. On the Configure Internet Connection – Connection Type page, select IP over ATM (IPoA)
then click "Next".
4. On the WAN IP Settings page, select "None" for WAN IP address settings. Then, select Use the
following DNS Server Address and key in the information that your ISP offered, e.g.:
Primary DNS server: 168.95.1.1
Secondary DNS server: 168.95.192.1
5. Check the Enable NAT box. And click "Next".
6. On the Configure LAN side Settings page, key in the information for your LAN, e.g.,
Primary IP Address: 192.168.1.1
Subnet mask: 255.255.255.0
Start IP Address: 192.168.1.2
End IP Address: 192.168.1.254
7. Check Configure the second IP Address and Subnet Mask for LAN Interface and enter the
information needed, e.g.,
Secondary IP Address: 10.11.80.81
Subnet mask: 255.255.255.248
Click Next.
8. Check the network information on the Summary page. Make sure the contents match the
settings provided by your ISP. Click Finish.
9. Now the router is correctly configured. You can access the Internet.

Bridge Mode

Description:
In this example, the ADSL Router acts as a bridge which bridging the PC IP addresses from LAN to WAN.
The PC IP address can be a static public address that is pre-assigned by the ISP or a dynamic public
address that is assigned by the ISP DHCP server, or an IP address received from PPPoE software.
Therefore, it does not require a public IP address. It only has a default private IP address (192.168.1.1)
for management purpose.
Configuration:
1. Choose a client PC and set the IP as 192.168.1.x (x is between 2 and 254) and the gateway as
192.168.1.1.
2. Start your browser and type 192.168.1.1 in the URL box to access ADSL web-based manager.
3. Go to Quick Start – Quick Setup. Uncheck Auto Scan Internet Connection (PVC). Key in the VCI
and VPI value, e.g.,
•
VPI – 8
•
VCI – 35
Then click the Next button.