Connection Type; Ppp Over Atm/ Ppp Over Ethernet - NetComm NB6 User Manual

The quick setup wizard will guide you to configure the ADSL router through some specific steps. Refer
to the following pages for detailed information.
Auto Scan Internet Connection (PVC):
If your ADSL router does not have PVC configuration inside, you can check this box. Otherwise, please
uncheck this box.
VPI (Virtual Path Identifier):
Identifies the virtual path, between endpoints in an ATM network. The valid range is from 0 to 255. To
enter the setting, please refer to the setting that the ISP offered. In Australia the default value is 8.
VCI (Virtual Channel Identifier):
Identifies the virtual channel endpoints in an ATM network. The valid range is from 32 to 65535 (1 to
31 is reserved for well-known protocols). To enter the setting, please refer to the setting that the ISP
gave you. In Australia the default value is 35.
After entering the VPI/VCI value, please click "Next" for the following step.

Connection Type

The system provides several protocols for you to choose. Your ISP will offer you the most suitable
settings of the protocol. Before you set this page, please refer to the protocol that your ISP offered.
After clicking on the Next button from the VPI/VCI web page, the following screen will appear. Please
choose the connection type and encapsulation mode that you want to use and click Next for next page.
For instance, PPP over Ethernet (PPPoE) is selected in this demonstrative figure.
Note: On some models there will be an option for EoA. EoA includes and is in place of PPPoE, IPoE and
Bridge Mode.

PPP over ATM/ PPP over Ethernet

If the connection type you choose is PPP over ATM or PPP over Ethernet, please refer to the following
information.