NetComm NB6 User Manual page 50

Select this item to set the DNS server addresses manually, type the information provided by your ISP in
the following Primary DNS and Secondary DNS server entries, e.g. 168.95.1.1 and 168.95.192.1.
Click Enable NAT if you want.
After setting up the WAN IP and DNS server information, click Next to open the following page.
On the Configure LAN side Settings page, you have to fill in the data requested.
Primary IP Address & Subnet Mask:
Key in the information, that is offered by your ISP for the LAN connection, e.g., 192.168.1.1 for IP
address and 255.255.255.0 for subnet mask.
MTU:
(Please refer to the PPPoA/ PPPoE section.) The default MTU setting here is 1500. You may modify it if
necessary.
Configure the secondary IP Address and Subnet Mask for LAN interface:
Check this box to set up a secondary IP Address to connect to your router if they are not included in
the range that DHCP server accepts. You have to key in the information received from your ISP for the
LAN connection, e.g., the secondary IP is 10.11.80.81 and the mask is 255.255.255.248 in the example
illustrated in the figure.
DHCP Server On:
Check this item if DHCP service is needed on the LAN side. The router will assign IP address and
gateway address for each of your PCs.
Start IP Address & End IP Address:
Enter the information needed.