NetComm NB6 User Manual page 52

Click this button to allow the system to get an IP address automatically.
WAN IP Address, WAN Subnet Mask, and Default Gateway:
When choosing Use the following IP address, you have to key in the IP address, the subnet mask, and
the default gateway provided by your ISP for the WAN interface.
If you choose to obtain the IP address automatically or use specific IP address, you have to decide
whether to select Obtain DNS server address automatically or Use the following DNS server address
and enter the information provided by you ISP.
The default setting is none, if selecting "Obtain an IP address automatically" or Use the following IP
address, the DNS setting appears, shown as the figure below.
Check Enable NAT if necessary.
Press Next to continue.
Primary IP Address & Subnet Mask:
Key in the IP address and the subnet mask that provided by your ISP for LAN interface, e.g.,
192.168.1.1 and 255.255.255.0, respectively.
MTU:
Please refer to PPPoA/ PPPoE.
DHCP Server On:
Check this item if DHCP service is needed on the LAN. The router will assign IP address and gateway
address for each of your PCs. Enter the information for Start IP, End IP and Lease Time if you enable
this function. The default value for lease time is one day.
DHCP Server Off:
Check this item if DHCP service is not needed on the LAN; like our example.