ETC ION Operation Manual page 52

• IP, CP, FP, BP . . . . . . . .Indicates that the value is referenced to a palette (Intensity,
• MK . . . . . . . . . . . . . . . . .Indicates the channel is marked for a later cue. The cue
• N. . . . . . . . . . . . . . . . . . .Indicates the value is null (from either {Make Null} or a filter).
• P . . . . . . . . . . . . . . . . . . .Indicates the channel is parked.
• Ph. . . . . . . . . . . . . . . . . .Indicates the channel is at a preheat level.
• Pr . . . . . . . . . . . . . . . . . .Indicates that the value is referenced to a preset. This text is
• Q. . . . . . . . . . . . . . . . . . .Found in the non-intensity categories of a marked channel.
• t . . . . . . . . . . . . . . . . . . .The channel has discrete (parameter/category-specific)
• + . . . . . . . . . . . . . . . . . . .Found in place of parameter data in summary view. Indicates
• ! . . . . . . . . . . . . . . . . . . .Indicates an ACN or RDM error.
The symbols that appear in the Mark flag include:
• D. . . . . . . . . . . . . . . . . . .AutoMark is disabled.
• R. . . . . . . . . . . . . . . . . . .Indicates a manual reference override. Manual changes have
• M . . . . . . . . . . . . . . . . . .Indicates a mark is placed, but manual, and must be stored.
• + . . . . . . . . . . . . . . . . . . .Indicates a cue is both a marking and reference cue when
• - . . . . . . . . . . . . . . . . . . .Indicates a dark move, a cue that has any non-intensity
• x . . . . . . . . . . . . . . . . . .Indicates that a mark has been placed, but the mark is
38
Color, Focus, or Beam). This text is followed by a number,
indicating which palette is being referenced. This can be
substituted with the palette label if the "Show Reference
Label" setting is activated (see
103). Holding down [Label] will toggle between the palette
label and palette number.
number is indicated in the other categories (see "Q" below).
followed by a number, indicating which preset is being
referenced. The preset label may also be shown if this setting
is enabled (see Show Reference Labels, page
down [Label] will toggle between the preset label and preset
number.
The "Q" is followed by a number indicating which cue the
mark is in preparation for.
timing.
that not all parameters in that category are at the same value.
This indicator is found only in the summary view or in table
views when the parameters are collapsed into a category
view.
been made that override a previously stored reference (such
as to a palette or preset). Once recorded, the reference will
be broken. If updated, the referenced target will be updated
as well, unless otherwise instructed.
Is blue when stored."m" indicates cue is not marking.
displayed in the mark flag.
parameters moving on channels whose intensity is at 0.
broken.
Show Reference Labels, page
103). Holding
Ion Operations Manual