Rfr Operation Modes - ETC ION Operation Manual

RFR Operation Modes

The Eos/Ion RFR defaults to opening in Live mode. There are other modes available in the RFR,
however. To switch modes, hold down the [Mode/More SK] button and then select the desired mode
from those available by pressing the appropriate softkey. Mode options are: Park, Live, Playback,
and Patch.
P a r k M o d e
This mode is used for parking channels and also for "channel check" and "address check"
functions.
S o f t k e y s
The following softkeys are available in park mode:
• Address
• Channel
• Last
• Full
• Out
• Next
{Address} and {Channel} are used to select addresses or channels for parking.
• <Channel> [7] [@] [5] [Enter] - Parks channel 7 at 50%.
• {Address} [8] {Full} - Parks address 8 at full.
{Full} and {Out} are used to set those levels for channels or addresses. {Out} parks the channel or
address at 0.
{Next} and {Last} are used for the check functions (see below).
• [9] [@] [Enter] - unparks channel 8.
C h a n n e l o r A d d r e s s C h e c k
When a single address or channel is selected, using {Next} and {Last} you can rapidly increment
or decrement through the channels or addresses to verify function. This only works when a single
channel or address is selected on the RFR and then {Next} and {Last} is used.
In this mode, the right thumbwheel will function as next and last commands, and the left will function
as the level wheel.
E
Remote Control 329